kshansen
Senior Member
- Joined
- Mar 11, 2012
- Messages
- 11,165
- Location
- Central New York, USA
- Occupation
- Retired Mechanic in Stone Quarry
Long story short back before I retired I did an inframe job on a 3-53 in a genset. Got a kit for the project but did not use the main bearings or crank thrust washers. Could not see leaving them at the old job where no one would know what they were or how to even install them!
These are Interstate-McBee parts have four main bearings # A-8924357 Std. mains for non-turbo 3-53 would need one more if you are doing a 4-53. Also a set of four crankshaft thrust washers # A-5116197.
The whole set should fit in a USPS small flat rate box for $7.15 to any US address. Give me a few dollars to make it worth my trip to the Post Office, say total of $15.00 and they are yours.
Send a Private Message or as it's called in this new format "Start a Conversation"
These are Interstate-McBee parts have four main bearings # A-8924357 Std. mains for non-turbo 3-53 would need one more if you are doing a 4-53. Also a set of four crankshaft thrust washers # A-5116197.
The whole set should fit in a USPS small flat rate box for $7.15 to any US address. Give me a few dollars to make it worth my trip to the Post Office, say total of $15.00 and they are yours.
Send a Private Message or as it's called in this new format "Start a Conversation"