PAPS Landscape
Member
- Joined
- Mar 22, 2005
- Messages
- 13
I have a 2000 NH 655e backhoe 4x4 and want to change the hoe control pattern from Deere to CAT, its a standard 2 level control. whats the best way to switch the controls to CAT??
-
Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!
Changing Hoe Control Pattern for NH 655e
- Thread starter PAPS Landscape
- Start date
amyliveshere
Well-Known Member
swap the pipes around on the valve block
nick......
nick......
JeremiahSr
Well-Known Member
no, dont swap around the hoses. different systems are valved according to some smart guys hydraulic evil plans. you will have to change over the linkages. will probally take a little fabricating but get creative and you can do it.
oldseabee
Senior Member
Ford used to have a kit for the 555A machines. It consisted of a set of linkage rods bent so that they would connect to the levers as usual but they now line up with the correct spool for the change in function or you could make up your own rods.
Not sure if this applies to the 655 but it is worth checking into.
Not sure if this applies to the 655 but it is worth checking into.
amyliveshere
Well-Known Member
dont know why you cant swap the pipes.from memory they are all 3/8 bsp
nick...........
nick...........
oldseabee
Senior Member
You can't just switch pipes because not all the valve sections have the same circit relief pressures, you could end up with low power on a function that requires full power.