Fairfieldcounty
Active Member
I have a CAT 246C that is presenting with a low speed condition that appears to be caused by the joystick. The machine will only move at about half speed ginghams forward until the joystick is brought back to neutral and then it will run at normal operating speeds when pushed forward again.
Could this be a bad sensor or something else before I dump an $800 joystick into it? Any way to check the joystick?
S/N : JAY08135
Could this be a bad sensor or something else before I dump an $800 joystick into it? Any way to check the joystick?
S/N : JAY08135
Last edited: