Hi All
I have added some remote hydraulics to an a25c water cart.
The specs say that the hydraulic pressure is 2900psi and I need 2500psi min., so all good.
However checked the pump 1 and 2 tests points underneath and I am getting 1500psi.
Have read manual and it says pump 1 and 2 should be at 350psi when idling?
Also machine is turning or articulating by itself on startup, steering wheel turns unmanned, which is not good, especially when loaded on a truck.
The steering is very light when used. I have put new tie rod end on the linkage arm.
Should I reduce pump 1 and 2 pressure to 350psi, but where can I get the 2900psi into the water pump line?
If anyone can assist me in understanding this it would be appreciated.
thanks
I have added some remote hydraulics to an a25c water cart.
The specs say that the hydraulic pressure is 2900psi and I need 2500psi min., so all good.
However checked the pump 1 and 2 tests points underneath and I am getting 1500psi.
Have read manual and it says pump 1 and 2 should be at 350psi when idling?
Also machine is turning or articulating by itself on startup, steering wheel turns unmanned, which is not good, especially when loaded on a truck.
The steering is very light when used. I have put new tie rod end on the linkage arm.
Should I reduce pump 1 and 2 pressure to 350psi, but where can I get the 2900psi into the water pump line?
If anyone can assist me in understanding this it would be appreciated.
thanks