When engine running, all hydraulics with exception of the platform swing work fine. When in the cage I push the swing Left or Right electric switch, I hear the engine load, but no movement at the platform. I pulled the three lines off and One line does have continuous flow, but not high volume. I see on the schematic that it is regulated flow to .2 gpm.
I can push the platform against a tree (with some hydraulic effort by other cylinders) and it does move.
I pulled the platform rotate solenoids off the main stack and fluid pours out of one port on the main block.
I applied 12 volts to both solenoids, and they both shuttle the valves back and forth (at the same time) so electrically they seem fine....
Any ideas? Possibly the platform motor is just too tight / bound up for the limited hydraulics to move? I hear the platform rotate isn't the strongest thing even on a good day... what's your experience?
Thanx.
I can push the platform against a tree (with some hydraulic effort by other cylinders) and it does move.
I pulled the platform rotate solenoids off the main stack and fluid pours out of one port on the main block.
I applied 12 volts to both solenoids, and they both shuttle the valves back and forth (at the same time) so electrically they seem fine....
Any ideas? Possibly the platform motor is just too tight / bound up for the limited hydraulics to move? I hear the platform rotate isn't the strongest thing even on a good day... what's your experience?
Thanx.