NH575E
Senior Member
Recently purchased a used backhoe that had those awful emergency battery cable ends on it. I know it's best to replace the whole cable but these cleaned up and looked decent except the original ends were gone. Could not find any 4/0 solder on ends local but found them HERE on the net. Nice that they actually had them in positive and negative also instead of universal. Got them in a few days and they fit the battery terminals and cable perfect. Just supported the cables in a straight out position, heated the terminals with a propane torch, and fed 40-60 rosin core solder in till they filled up. I didn't think to order any large heat shrink so I taped off the cable side with electrical tape. Machine fires right up!