• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Search results

  1. J

    D8k dipstick measurement

    Anybody have a chance to measure there dipstick to the full warm running line while we wait for a replacement part D8k 7v13039
  2. J

    Pin removal with broco torch

    Wish I had made a video the pile of red hot lava looked cool so snapped a pic it took about 20 inches of 1/2 inch cutting rod and maybe 5 seconds to burn this 2 inch bolt off and pierce it loosen it
  3. J

    Cat hydraulic cylinder bench the easy way

    Repacking tilt cylinder on 950g homemade 4 inch wrench for the 980g to push on bolt though the back bumper and oak v block makes for a solid setup light ratchet straps help pushing the head back onto the rod I always break the sharp edge of the rod to help it slide back together better
  4. J

    A little grader fun

    Trans burned a clutch pack pulled the differential and finals to have cat rebuild also while we were in there got it all tied up before dark
  5. J

    966 F brake replacement

    966f ser 4yg00660 Need to put brake pads seals ect in front end does anyone have service manual information or tips for this job any special tools required? Thanks in advance Jonas
Top