RobVG
Senior Member
- Joined
- Jun 20, 2009
- Messages
- 1,028
- Location
- Seattle WA
- Occupation
- 17 excavators and a stewpot of other stuff
I thought I'd post this in case it might help somebody :spongebob
-Check for controller failure first.
Remove vent housing on top of main plastic housing- push in on sides and pull up. Remove main housing. Two bolts are underneath the vent housing and there is one at the bottom of the compartment on the left under a round cover with a screwdriver slot- turn left 1/4 and pull cover out to get to the bolt.
Remove seat, pedestal and ducting. Seat has 4 allen bolts in the front and the back of the rails. I had to unbolt the fuse block bracket to get the seat back far enough to get to the front two allen bolts. If you're by yourself its easier to roll the seat out over the sticks and through the front window.
Remove the brackets and misc bolts holding the cover where the computer sits and gentle move the whole mess towards you to get at the motor hosing. I took the duct off the motor housing because it makes it a little easier to get to the mounting bolts and it makes unplugging the duct easier.
Now is a good time to clean the filters
-Check for controller failure first.
Remove vent housing on top of main plastic housing- push in on sides and pull up. Remove main housing. Two bolts are underneath the vent housing and there is one at the bottom of the compartment on the left under a round cover with a screwdriver slot- turn left 1/4 and pull cover out to get to the bolt.
Remove seat, pedestal and ducting. Seat has 4 allen bolts in the front and the back of the rails. I had to unbolt the fuse block bracket to get the seat back far enough to get to the front two allen bolts. If you're by yourself its easier to roll the seat out over the sticks and through the front window.
Remove the brackets and misc bolts holding the cover where the computer sits and gentle move the whole mess towards you to get at the motor hosing. I took the duct off the motor housing because it makes it a little easier to get to the mounting bolts and it makes unplugging the duct easier.
Now is a good time to clean the filters