The hydraulics have stopped working all of a sudden.On repeated attempts the hydraulics work for a minute or two after intervals.We adjusted pilot pressure heand the hydraulics worked for slightly longer.We have replaced the pilot gear pump but the problem persists.Kindly advise.
-
Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!
funwithfuel
Senior Member
The magnet on your safety solenoid has likely failed. Please replace with magnet of high speed travel. This will verify the problem and get you running til parts are available.
If memory serves, it should be the magnet closest to counterweight as you open the pump room door
If memory serves, it should be the magnet closest to counterweight as you open the pump room door
funwithfuel
Senior Member
Serial number please
Serial no. is 3966
funwithfuel
Senior Member
5 digits for serial.
funwithfuel
Senior Member
funwithfuel
Senior Member
funwithfuel
Senior Member
Look at the orientation, in the valve. Identify and mark the wiring, measure voltage, to confirm.
High speed travel is almost always at opposite end of valve bank. Good luck, be safe. By the way, there is a manual plunger you can depress with a pick if someone else can pull a function for you to absolutely confirm.
You just need the magnet, no need to open hydraulic system or make adjustments
High speed travel is almost always at opposite end of valve bank. Good luck, be safe. By the way, there is a manual plunger you can depress with a pick if someone else can pull a function for you to absolutely confirm.
You just need the magnet, no need to open hydraulic system or make adjustments
funwithfuel
Senior Member
That is hammer solenoid, not safety