Planning a rebuild on a V1200 Tramac Hammer does anyone know where I can find a complete parts list and or diagram? Where is the best place to locate parts. Any tips or advise I know there are probably guys in this forum that have rebuilt hammers extensively and could offer some of the ins and outs to help me save time. Thanks in advance for any help. The plan is to definitely do a soft rebuild (gaskets,seals,ect.) and probably going to have to replace piston. The hammer sat for a while and then started passing hydraulic fluid so I'm assuming the piston rusted and blew out the seal. Any hard parts would be replaced depending upon condition after opening the hammer.