1. Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!
  2. ALL NEW MEMBERS READ THIS FIRST!! Thank you for joining Heavy Equipment Forums! If you are new to forums we communicate with "Threads", please search our threads to see if your topic may have already been answered and if not then click "Post New Thread" in the appropriate forum. This will allow all of our members to see your question and give you the best chance to be answered. After you've made a number of posts you will graduate to Full Member status where you'll see a few more privileges. Following these guidelines will help make this the best resource for heavy equipment on the net. Thanks for joining us and I hope you enjoy your stay!!

Tl 230 want start

Discussion in 'Skid Steers' started by chris allen, Jun 30, 2022.

  1. chris allen

    chris allen Senior Member

    Feb 11, 2014
    Feild tech
    Helped a fella rework his motor, got it all
    Back together and can’t get the key to start it over, checked all fuses, key switch,relays, have traced power all the way back to under kick pannel above ur feet is were the computer is an few relays, found one with a tag on it. It says STIL on it, the relay to the left of it is for the horn. I can unplug the stil relay an put a jumper wire in it an can turn the key an crank the motor up, but then no hyds opperate, Have checked the arm
    Rest switch that turns hyd oil on, it does have 12 volts on it an when arm
    Rest is let down it does send the 12 volts out of it ? The schematic shows for it to of had operator seat switch’s but I did t see one nor was there any wires under there, Don’t think I’ve ever seen a seat switch on Takeuchi skid steer . Repair manual didn’t really give a troubleshooting breakdown for the starting circuit

    Attached Files: