1. Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!
  2. ALL NEW MEMBERS READ THIS FIRST!! Thank you for joining Heavy Equipment Forums! If you are new to forums we communicate with "Threads", please search our threads to see if your topic may have already been answered and if not then click "Post New Thread" in the appropriate forum. This will allow all of our members to see your question and give you the best chance to be answered. After you've made a number of posts you will graduate to Full Member status where you'll see a few more privileges. Following these guidelines will help make this the best resource for heavy equipment on the net. Thanks for joining us and I hope you enjoy your stay!!

Source for running 3204DI replacement in a 926E??

Discussion in 'Wheel Loaders' started by 02Dmax, Dec 15, 2015.

  1. 02Dmax

    02Dmax Senior Member

    Joined:
    Dec 5, 2007
    Messages:
    666
    Location:
    MO
    926E 94Z02469

    3204DI 45V75771 ARR# 7C0934


    As usual I'm working on a loader that just gets used now and then, so the owner obviously isn't real excited about going with a $10k long block from Cat. I googled "used 3204" but didn't come up with much. I use Vanderhaags for used truck stuff but the only 3204 they have has a hole in the side of it.

    Just wondering if any of you guys know of a respectable equipment dismantler to point me towards. I know there aren't a ton of these out there but there are still a few I run across. Thanks!
     
  2. grandpa

    grandpa Senior Member

    Joined:
    Oct 16, 2009
    Messages:
    1,786
    Location:
    northern minnesota
    1 800 252 5804 ask for Loren...
     
  3. 02Dmax

    02Dmax Senior Member

    Joined:
    Dec 5, 2007
    Messages:
    666
    Location:
    MO
    Thanks!
     
  4. ben46a

    ben46a Senior Member

    Joined:
    Mar 11, 2007
    Messages:
    773
    Location:
    Waverley NS/Fort Mac AB
    I think the cat reman will be about the only option. I just kicked one out the door after kicking a rod and engine swap, cat was the only one we could find anywhere. If the block isn't too bad it could be welded up and the crank machined to make it operational.
     
  5. 02Dmax

    02Dmax Senior Member

    Joined:
    Dec 5, 2007
    Messages:
    666
    Location:
    MO
    Thanks again for the referral. Loren hooked me up. 5200 for a good running takeout with verifiable hours and records. I'll definitely be using him again.