1. Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!
  2. ALL NEW MEMBERS READ THIS FIRST!! Thank you for joining Heavy Equipment Forums! If you are new to forums we communicate with "Threads", please search our threads to see if your topic may have already been answered and if not then click "Post New Thread" in the appropriate forum. This will allow all of our members to see your question and give you the best chance to be answered. After you've made a number of posts you will graduate to Full Member status where you'll see a few more privileges. Following these guidelines will help make this the best resource for heavy equipment on the net. Thanks for joining us and I hope you enjoy your stay!!

Please I need your help guys

Discussion in 'Generators/Gensets' started by alaa, Sep 8, 2017.

  1. alaa

    alaa Well-Known Member

    Joined:
    Jan 31, 2017
    Messages:
    48
    Location:
    kasa
    Hi gents,
    I genset 3512B FDE the alternator burnt due to short cables , I'm going to swap Mitsubishi alternator to cat generator

    so I need all schematic diagrams with EMCP ii +

    GENSET SN: CAT00000LFDE00345
    ENGINE SN: CTH00441
    ENGIEN MODEL : 3512HD
    Thanks in advance
     
  2. alaa

    alaa Well-Known Member

    Joined:
    Jan 31, 2017
    Messages:
    48
    Location:
    kasa
    No one
     
  3. Cmark

    Cmark Senior Member

    Joined:
    Jan 2, 2009
    Messages:
    2,263
    Location:
    Australia
    Here you go...
     

    Attached Files:

  4. alaa

    alaa Well-Known Member

    Joined:
    Jan 31, 2017
    Messages:
    48
    Location:
    kasa
    Cmark.....
    I do not know how to describe my thanks to you
    Thanks a lot
     
  5. alaa

    alaa Well-Known Member

    Joined:
    Jan 31, 2017
    Messages:
    48
    Location:
    kasa
    I have one more question
    The ECM that I have is 40 pin and the drawing shows 70 pin ECM and the generator harness connector E-C31 is 40 pin
    My question is
    The wire name on 70 pin ECM is same on 40 pin ECM with different location numbers ?
    Thanks for the one who helped me ( Cmark ) and who going to give some advice?
    My best regards
     
  6. Cmark

    Cmark Senior Member

    Joined:
    Jan 2, 2009
    Messages:
    2,263
    Location:
    Australia
    Can you see any part numbers on your 40 pin ECM?
     
  7. alaa

    alaa Well-Known Member

    Joined:
    Jan 31, 2017
    Messages:
    48
    Location:
    kasa
    By tomorrow I will check .... but what I have now just the serial no for the engine and the Gen-set..
     
  8. alaa

    alaa Well-Known Member

    Joined:
    Jan 31, 2017
    Messages:
    48
    Location:
    kasa
    I am trying now to matching from the troubleshooting files and schematic drawing with the numbers of wires and their colors