looking for 1" 3/16 10 spline yoke

[farmerlund]

My dad has a Danuser pto post auger with a wore out yoke on the gearbox. Danuser will not sell me a new one with out converting it to the new style safety pto shaft at $475. I will spare you all a 5 min rant about that.

Anyway I need a 1 3/16" 10 spline yoke. I can machine it to fit. mostly need a length of stock that will go over the spline or a new yoke that is close to start with. I am told it is a Rockwell yoke. but have not any luck looking it up. any links or ideas would be a great help.
No 885 yoke.

 

[crane operator]

http://media.spicerparts.com/cfs/files/media/DxTnY2spgbjMjTzha/j300-p4.pdf?store=original

Will help if you take measurements. They had several 10 spline, but all strap style yokes that I saw, I'm not sure what the 1 3/16" measurement in the parts book refers to.

 

[Junkyard]

I will look in my stuff. I have quite a bit of older stuff from a friend that closed his AG shop down when he retired. 3 40' containers worth! I know there are quite a few PTO shafts, u-joints and yokes.

 

[Jonas302]

Weasler 801-1210
https://www.drive-lines.com/weasler/12.php

Splined yokes about 1/2 way down the page

 

[Tinkerer]

]I don't know if this helps, but 3/16 of an inch is 0.1875.
There a several 1.188 on this website. http://www.northerndrivetrain.com/category/cat_endyokes_splined_10splines_1-188-10Spline.html

 

[farmerlund]

Ordered one from Tinkerers link. thanks. will need to machine the outer hub down a little. but should be able to get it to work.

 

[farmerlund]

Presto. one 10 spline yoke. made a little fixture to hold it in the lathe. Than machined off .230 from the diameter of seal area, and shortened it by .400. fits like a glove. Just have to get a new ujoint. Total cost= $72 plus 1 hr fooling around with lath.

 

[Ronsii]

Nice work