Hydraulic hammer

[KAF10]

Looking to see if anyone recognizes this hammer. I don’t see any markings other than what looks like “silent” written on the side. I’m assuming you charge nitrogen on the back head although I don’t see any normal ports other than this banjo style bolt in the head.
Any help would be greatly appreciated.

 

[Tags]

It “looks” like an Indeco hammer to me, but I can’t say thats it for sure.

 

[Diesel Dave]

OMAL from Italy…model not sure.

USED BREAKERS – NEW OMAL s.n.c.

www.newomal.it

 

[92U 3406]

That's where you'd probably charge it from. Looks like you'll need the adapter kit to do it though with that style of fill valve.

 

[KAF10]

That’s what I figured, do you know what style adapter they use? All the hammers I’ve dealt with use the needle style valve that you just push in.

 

[KAF10]

OMAL from Italy…model not sure.

USED BREAKERS – NEW OMAL s.n.c.

www.newomal.it

Thanks a lot. Never even heard of it.

 

[92U 3406]

That’s what I figured, do you know what style adapter they use? All the hammers I’ve dealt with use the needle style valve that you just push in.

Not off hand, no. When I specialized in attachments a few years ago just about every hammer that came in the door could be charged with one of about 4 or 5 different charge kits. So its not like you should have too much trouble finding one.

Can you post a better picture of the screw?

 

[KAF10]

Not off hand, no. When I specialized in attachments a few years ago just about every hammer that came in the door could be charged with one of about 4 or 5 different charge kits. So its not like you should have too much trouble finding one.

Can you post a better picture of the screw?

I’ll have to get you a better picture. The head of the bolt is just a standard hex. The threaded section is hollow with two holes on each side near the head of the bolt.