Hello everyone, I just rebuilt the engine and popped it back into my D4C. She fired right up and everything seemed good to go but I had no blade functions. It is not the control lock out as it lets me go into gear and move back and forward. I can back drag the blade over a pile in float mode and it then I can make it stay raised that way. But I put input in to drop it when it's suspended it will go down. It did that when the machine was off before so I suspect that's not indicative of what's going on.
I never removed the gear pump from the frame and I pulled the engine off by just slipping it off the spline. The hydraulic fluid is full. My manual is really really terrible and very hard to search through but I found that there is a lift solenoid and a tilt solenoid and they are both tied to the same fuse (Fuse 2S6024 See attached). I think this is a good starting place but I actually can't find the fuse. I know that sounds dumb but if anyone can point me in the right direction I would appreciate it.
I would also appreciate it if anyone else had any other ideas. I am going to put a gauge on the hydraulics after I find this fuse. My manual is so bad I'm having a hard time seeing where to put the gauge too.
I never removed the gear pump from the frame and I pulled the engine off by just slipping it off the spline. The hydraulic fluid is full. My manual is really really terrible and very hard to search through but I found that there is a lift solenoid and a tilt solenoid and they are both tied to the same fuse (Fuse 2S6024 See attached). I think this is a good starting place but I actually can't find the fuse. I know that sounds dumb but if anyone can point me in the right direction I would appreciate it.
I would also appreciate it if anyone else had any other ideas. I am going to put a gauge on the hydraulics after I find this fuse. My manual is so bad I'm having a hard time seeing where to put the gauge too.