MartinDR1025
Active Member
About to remove and replace the engine in my 580C. It has the shuttle. Is there and easy way to deal with the torque converter as far as install. Ive never messed with one of these. THANKS!!!
-
Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!
Case 580C Engine Swap
- Thread starter MartinDR1025
- Start date
Shimmy1
Senior Member
Send Tinkerer a pm with your email, and I think he'll send you a digital manual.
Tinkerer
Senior Member
There isn't much in the service manual about your question Martin. But this has been thoroughly discussed before on HEF.
Here ---> https://www.heavyequipmentforums.co...ackhoe-engine-torque-converter-install.75852/
Here ---> https://www.heavyequipmentforums.co...ackhoe-engine-torque-converter-install.75852/
Tinkerer
Senior Member
I will add that if you leave the torque convertor in the shuttle when the motor is removed there is very little to no chance of damaging the oil seal that the convertor shaft slides into.