• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

voltage

  1. S

    CAT 259D sensor voltage errors

    2204-3 Auxiliary Lever #1 Position Sensor Voltage Above Normal 2475-3 Right joystick Forward/Reverse position sensor voltage above normal 2477-3 Right Joystick left/right position sensor voltage above normal I am unable to move the bucket at all and I assume that has to do with the "right...
  2. P

    JLG 450A Yr 2000 Ford Dual Fuel Gas/Propane-Platform controls DO NOT work, Ground Control Works Fine

    2000 JLG 450A Dual Fuel Gas/Propane, Starts and runs great on either fuel. Ground controls work fine. You can start it from the platform but when you step on the dead man's pedal nothing works. Just no Power to any controls on the platform and it doesn't rev up when pressing the pedal. You can...
  3. J

    Losing Voltage to Starter on 2002 LiftKing Forklift

    Drops from 12.5 to 8 volts when turning on ignition. Won't engage the solenoid. New starter and solenoid are already installed. Any ideas to where its pulling voltage towards?
  4. D

    Cat 259d low voltage

    I keep getting a low voltage message on machine replaced the battery message went away for couple days than came back, tested the battery it was good so replaced the alternator and voltage went back up to around 14.2v for about 2 days now its dropping below 11v with the error message and wont...
  5. TEX32

    Technician requires some insight ( Energized frame w/ batts off )

    Afternoon fellas. Licensed tech here ( 20 years ) Need a hand trying to figure this one out... Details: Cat 980G. 4 batteries, 2+2 set up, 24 volt system. ( obviously ) - When batteries ON, frame is grounded 100% - When batteries are shut off, frame energizes to 95% source voltage. ( 25.6...
    • TEX32
    • Thread
    • 24v 980g batteries disconnect electrical energized frame positive short voltage
    • Replies: 97
    • Forum: Tractor/Loader/Backhoes
Top