• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

turbo

  1. P

    Cat 428 3054 engine spurting oil from dipstick

    Hi all, I’ve got a 428C backhoe with a retro-fitted 3054 engine Serial No. 7BJ46984 in it. Originally had a NA engine in it which broke a rod, and I picked this up on the cheap so stuck it in. Its got a couple of issues basically: - I’ve changed the turbo on this engine 3 times, and they keep...
  2. G

    bobcat t770 turbo

    Hello I have a 2012 bobcat t770 skid steer the serial number is A3P812359. It has a bad turbo on it i cant seem to find a part number off the turbo. ive contacted the dealer and they are useless. can anyone help me source an aftermarket turbo or the part number for the turbo.
    • genis
    • Thread
    • bobcat bobcat t770 t770 turbo
    • Replies: 1
    • Forum: Skid Steers
  3. P

    Cat 308E turbo

    Hi all, after not using excavator for a few months, was going over everything and noticed what seems to be an oil leak around turbo. should I be worried? if so, what would be the possible causes? Anything I can look at to do to rectify this. thanks in advance paul
  4. Boreal

    Should I hear the turbo spool down at shutdown

    I have a CAT 252b3 with the turbo 3.4. In the warmer months I hear the turbo spool down when shutting down but now in the colder temps I don't hear it. My shutdown procedure is pretty consistent. I let it idle for a few minutes then shut her off. And I don't notice any lack of power so I assume...
  5. R

    New holland turbo question

    Hey guys. Iv been here for a few years and seem to always be looking through this site for info. I can't seem to figure this one out hopefully someone can help. I have a 04 ls170. I bought the machine as is and it was dumping oil out the exhuast. Of course I assume turbo and sure enough the...
    • Raddy
    • Thread
    • l170 ls170 newholland skidsteer turbo
    • Replies: 8
    • Forum: Skid Steers
  6. 9

    Cat D9N 3408 coolant loss

    Gday guys. I have started to find a few issues in my 3408 engine. Coolant loss in my system has been approximately 20-30 litres over 15 hours however most of this is expelled through the cap when I take it off to check it sometimes. The engine has not been getting hot however the radiator is...
    • 988Driver
    • Thread
    • 3408 caterpillar coolant in oil d9n head gasket? turbo
    • Replies: 7
    • Forum: Dozers
  7. A

    Smoking after tipping forward - Bobcat 863G

    Borrowed my 863 out and my friend tipped it forward on a hill with a full bucket. I checked the oil and it was only down maybe a half quart. When I went to load it on the trailer it was smoking blue pretty good but cleared up for the most part after it ran for a while and warmed up. A few...
  8. P

    Cat DGN Turbo Failure and Air pre-cleaner heat damage

    My best guess is : muffler rusted and restricted. Caused Exhaust back-flow through dust ejection - caused motor to run hot - caused air cleaner to accelerate restriction through dust load and melting pre-cleaner pitons. Would appreciate the opinions of others. Also, Although I have removed the...
  9. F

    Bobcat T190 Turbo problems

    Hello everyone! First post to this site, all I have to say so far is there is a TON of knowledge on this site, and Im glad I found it!!! Ill warn you all now, this is a long post. Im trying to put as much out there as I can that I have done/checked already. First off, im working on a T190 on...
  10. D

    TL150 Yanmar 4TNV106T-XTBL Engine Issues

    Hey all, Have a 2004 Takeuchi TL150 powered by a 4 cylinder Turbo Charged Yanmar 4TNV106T-XTBL. I am not the first owner. Currently use it around my small farm for fence building, moving earth and other tasks. Some uniqueness to this setup... Intake heater, electric fuel priming and dummy...
  11. C

    Isuzu service engine soon light..

    hi guys Need some help. I have a Isuzu for 900 sites 220. The service engine soon light comes on and it goes into limp mode. I had it scanned and was told I had low fuel pressure. I changed the pump and it ran good for a few days and now it’s playing up again. When I got it scanned he said I...
    • Chris steer
    • Thread
    • engine lights fuel pumps isuzu turbo
    • Replies: 2
    • Forum: Trucks
  12. B

    Case tr 310 blow turbo 120 hrs

    New to forums, we run all case alpha 3 sv 250 2 tr 270 1 tr 310. We live the 310 by far the smoothest operating of all our alpha series. Beginning of the week blew the turbo. We think the seals were bad from the factory has anyonever else had similar issues?
Top