• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Search results

  1. 3

    2004 zaxis 200LL

    Have seen this on a couple of hitachi log loaders check wiring in hydraulic pump compartment specifically engine speed sensor. Will cause no start erratic hunting governer issues
  2. 3

    Exhaust Pipe Wide Band Clamp Question - How Would You Fix This?

    Don’t know about longer band clamps but that looks like an ideal place for a section of flex pipe and a band clamp on each end
  3. 3

    how do you move a dead excavator

    So pop final cover pull gear reinstall cover and tow will have no brakes. To hook another machine up hydraulically will require a fair amount of redneck engineering
  4. 3

    how do you move a dead excavator

    Sorry couldn’t see clear enough. Basically need to know how many hydraulic lines are in that housing. 3 probably has brakes internal to motor or requires motor to have hydraulic power 4 probably has brakes internal to final housing that line can be pulled and pressurized with ports power to...
  5. 3

    how do you move a dead excavator

    Why do you need to tow ? Major engine failure? Electric fire? Hydraulic failure? Please remove cover from inside final post pic of travel motor area.
  6. 3

    Vermeer 1250 Turbo hydraulic issues

    Well looks like covered all the bases only other thing I would check is crank shaft end play. If good probably speed control
  7. 3

    Readying for the KW

    Have been watching this am extremely empressed not many that can do everything. Engine rebuild body work air brake problems paint and body ect. Seems your a top hand why did you step out of the shop ??
  8. 3

    FACTORY RADIO IN CASE 1150K 2007 DOZER

    Is easy to check key on engine off lights off radio good bad.
  9. 3

    FACTORY RADIO IN CASE 1150K 2007 DOZER

    The aftermarket LED work lights will cause radio static especially the 6 to 36 volt type. Maybe the transformer in them??
  10. 3

    How do you repurpose or recycle your used grease?

    Brush pile fire starter
  11. 3

    FACTORY RADIO IN CASE 1150K 2007 DOZER

    alternators and LED light will cause radio interference
  12. 3

    Volvo A40D no communication with ECM's not enough power to pull a hill

    So 65 psi fuel pressure good. Turbo doesn’t seem to spool up. Have you checked for air to air leaks ? Make up adapter and pressurize to 30 psi check for leaks. Indicator of low boost is excessive engine heating does it get hot pulling up hill ?
  13. 3

    Just another day in paradise

    Yep could be. Especially if fuel pump in trunk run off of that fuse. If fuel pump in trunk doesn’t run will have bogging issues
  14. 3

    New bad noises from the 3406B!

    Pop the valve covers look real hard at valve train. Missing button on rocker ??
  15. 3

    Ingersoll Rand/Isuzu Diesel on Runs with Key ON

    Grab a test light check power at engine temp sensor and oil pressure sensor could have bad sensor
  16. 3

    D5H Brakes dragging

    When you replaced trans pump did you clean torque converter screen? Is problem right after initial warm up or 2 to 3 hours into the day
  17. 3

    Doosan DL250-3 electrical

    So I know nothing about dooson but ran into this identical problem on a John deere 744h a few years ago took a while to figure it out long story short ended up being pump control
  18. 3

    Kobelco SK200 LC

    can show pic of out side of injection pump ?
  19. 3

    Kobelco SK200 LC

    years ago did conversion from mtubusi engine to cummins on kobelco log loader was sitting on crane carrier lower
  20. 3

    Kobelco SK200 LC

    so picture looks like shut off for cummins 5.9 if am right will need electrical solnoid to turn on/off fuel
Top