• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Search results

  1. J

    963 cat track loader code

    Sn 2ds 2296 need help with code. 030. 248.02. 030. 271.05. 079. 190.08 079. 467.03. Intermitten no steer . This is the active code in dash need help with this problem please
  2. J

    case cx210 wont start

    yes I can jump the switch side of the relay and engine will start and run but high idle is 1700 and engine bogs down when you work a function. but I think I would be wise to buy a relay and go from there. thanks for the feedback.
  3. J

    case cx210 wont start

    yes I have gone through all fuses . but I did not think 2.9 volts was enough power to fire a 24 volt relay . most ecm I deal with signal with 5 to 7 volts.
  4. J

    case cx210 wont start

    thanks for all the replies. I found the vp 44 relay it only has 2.9 volts to the coil side . traced it back to the ecm and that is the voltage coming out. wire harness is good. jumped the switch side of vp44 relay engine starts and runs. but falls on its face when under a load. active codes in...
  5. J

    case cx210 wont start

    Thank you for your help. Hopefully this will help me get the answers I need. I will eventually learn to navigate this.
  6. J

    case cx210 wont start

    I am a new member, trying to navigate this system. Does anyone know why I have an eyeball viewing me? I have a piece of equipment with no power to lift or injection pump. Any thoughts? There are no blown fuses, suspect the problem is a VP 44 relay but cannot located it on equipment. Also no...
  7. J

    case cx210 wont start

    thanks for the reply. im new to this forum and not sure im doing it right because you are the first person to reply. im going to work on that machine today and I will use your advise.
  8. J

    case cx210 wont start

    engine wont start . no power to lift pump or injection pump. I suspect the vp 44 relay but I cant find it on the machine. could anyone tell me where this relay might be located. thanks
  9. J

    case cx 210 sn DAC212267 WONT START

    ENGINE TURNS OVER BUT WONT START. THERE IS NO POWER AT FUEL LIFT PUMP. WOULD LIKE TO KNOW WHERE FUEL LIFT PUMP RELAY IS LOCATED. I PUT POWER TO FUEL LIFT PUMP MAKES 9 PSI BUT ENGIN STILL WONT START. UNPLUGED HARNES AT INJECTION PUMP AND PLUGED IN A TEST HARNES FOR A 5.9 CUMMINS AND ENGINE WILL...
Top