• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Search results

  1. W

    Thumb teeth hitting bucket teeth

    I just got a new 30in bucket for my 442 Bobcat and the thumb teeth hit dead center on bucket teeth, was wondering if this will cause a problem, all my other machines with thumbs hit between bucket teeth.
  2. W

    Oil in bell housing

    I am getting the starter back today and will check the pump drive oil when I get back to the machine, Thanks for the help!
  3. W

    Oil in bell housing

    I figured it was the rear main seal, sad part we just rebuilt the motor, might have 75 hrs on it, I asked the question because there was a gasket between the starter and the bell housing.
  4. W

    Oil in bell housing

    FF0200x501452 serial number From the color it appears to be engine oil
  5. W

    Oil in bell housing

    My JD 200 lc starter was acting up so I pulled it off and there was a lot of oil on the starter, when we tore it down the starter had oil inside of it, my question is should there be oil in the bell housing or do I have a leaking rear main seal.
  6. W

    john deere 200lc throttle problem and more......

    Yes I found the problem, it was the fuel shut off solenoid, bought one off ebay for 48.00, running like a champ now!
  7. W

    john deere 200lc throttle problem and more......

    I went yesterday afternoon and reset the throttle with the little toggle switch by the fuse box and rechecked all the fuses,the fuse that is 5th from the left on the top row was blown, I replaced the fuse and the machine fired up and the throttle worked as it should for about 2 minutes then shut...
  8. W

    john deere 200lc throttle problem and more......

    ser#ff0200x501452. Machine was running fine and shut down suddenly,will start and shut off when trying to restart. I found the solenoid that shuts off the fuel will open and machine will start,immediately upon starting the solinenoid will close and shut off fuel. If I continue cranking it will...
  9. W

    John Deere 200lc not throttle response

    I am having a similar problem with my 200lc so I will be following this thread!
  10. W

    John Deere 4120 fuel injector problems

    pumpguy the supply pump is bad, new one is suppose to be here tomorrow, I will let u know if that fixes the problem,Thanks for the advice. MG I have not checked the shims but I do not think there were any, if pump dose not fix it I will look, Thanks for the help from both of you!
  11. W

    John Deere 4120 fuel injector problems

    Good question,hadn't thought of that!
  12. W

    Hard Starting Galion 503L Diesel Engine

    I have the same grader and engine and you have to use the glow plugs and hold the button down until your finger hurts. mine has a meter that when the button is held down it will peg out, if some of the glow plugs are bad the meter will not go all the way over. You can buy them off Amazon, whole...
  13. W

    John Deere 4120 fuel injector problems

    Thanks, the injection pumps and injectors are new so I am leaning towards the supply pump, it dumped a lot of fuel in a short time and I am pretty sure we did not mess up the o rings when we installed the pumps, did not have to force them in, Thanks again for the help and you're welcome any...
  14. W

    John Deere 4120 fuel injector problems

    Thanks, it is fuel,no doubt about that, did not have this problem until after changing pumps and injectors.
  15. W

    John Deere 4120 fuel injector problems

    I replaced the pumps and injectors, it is a mechanical engine. The injection pumps, this is not the correct name, slid in with little resistance. the engine seemed to have a slight miss when we first cranked but was running better the longer it ran. We only ran the engine a few minutes before it...
  16. W

    John Deere 4120 fuel injector problems

    I replaced the fuel injector assemblies in my brothers tractor, got it back running and changed the oil and filter because of fuel in the oil,ran it for a few minutes and it ran fine, checked the oil level and it is way over full and has fuel in it,Thanks for any help. Engine is a 4024t
  17. W

    John Deere 200LC warning lights

    It was the battery relay, I tapped it and the lights went out! Thanks for the info
  18. W

    John Deere 200LC warning lights

    I will check this today, Thanks for the help!
  19. W

    John Deere 200LC warning lights

    Disconnected wire to alt and charge light went out but oil light stayed on
  20. W

    John Deere 200LC warning lights

    If I disconnect the wires and that fixes the problem does that mean my alternator is bad?
Top