• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Search results

  1. 007

    Truck Differential Question

    Hi Guys, just looking for opinions on a diff Puzzle. I am building a site rock dumper trailer based on a truck diff from a truck that was about 6-8ton? I will probably only carry about 4 tons max. I am trying to lighten up the axle by removing the center and axles as they are not needed. If i...
    • 007
    • Thread
    • Replies: 19
    • Forum: Trucks
  2. 007

    Hydraulic Motor Question for a hydraulic wizz Please

    I have just purchased a Sauer/Danfoss 151-315 orbital motor with the hopes of using it on my EX aux circuit. It is new but been unused and stored for at least 5 years. It has hoses that were plugged and clean and was originally tested ok apparently. It is not seized but when you rotate the shaft...
  3. 007

    KingPost Bushes

    Hi Guys, i have an almost new excavator and if i measure the lower kingpost pin and bush clearance from side to side using a dial gauge i have .035'' or .889mm without putting a huge amount of weight on it which probably will produce more. Has any one fitted new pins and bushes to a machine and...
  4. 007

    Expected Clearance with new KingPost bushes and pin

    Hi Guys, i have an almost new mini excavator and if i measure the lower kingpost pin and bush clearance from side to side using a dial gauge i have .035'' or .889mm without putting a huge amount of weight on it which probably will produce more. Has any one fitted new pins and bushes to a machine...
  5. 007

    New Kubota U25 King Post Bushes Clearance

    Hi Guys, Operating a new Kubota U25 and there is an annoying thumping noise coming from the king post bushes and there is plenty of grease by the way. There is a little play in the bushes which i would have preferred none being a new machine but there is about 3mm movement up and down. Should...
  6. 007

    New Kubota U25 Blade Ram Not Holding

    Hi Guys, On any new machine would you expect the blade cylinder to hold indefinitely? Working on steep slop I have to keep pushing the blade down every 10 minutes or so as it is fading. Is very annoying and I have worked machines where this does not happen. Do you think it should be fixed by...
Top