• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Search results

  1. A

    Champion 710 A transmission problem

    Today went out to motor grader and removed the console and looked for the micro switch on the forward and reverse lever that Laycobeau mentioned, everything looked ok, but then notice the wiring harness to the solenoid circuits was unplugged and must have vibrated out to where the pins attach...
  2. A

    Champion 710 A transmission problem

    Thank you all for the information, I will check it this week maybe tomorrow, I did see the solenoids on front of the transmission just as you described, they have the nut on top of the shaft and they do not look to hard to get too. At first when the machine would did not move the error code of...
  3. A

    Champion 710 A transmission problem

    Thank you I will check that. I printed a 8400 electrical troubleshooting guide for a champion road grader, and the location of the fuse panel is not where they describe it and not so easy to access as the manual suggest, so it may not be a 8400, I will have to remove the console to get to the...
  4. A

    Champion 710 A transmission problem

    champion 710a I'm not sure what transmission it has in it. The serial # is 710a-157-15-16460, on the housing of the transmission casing is #29701 on top 687d below it those number are cast into the body of the transmission, I could not find where the tag is located do those #s help, I could...
  5. A

    Champion 710 A transmission problem

    champion 710a Thank you for your reply, how would you check the transmission pump failure, or the accessory drive? There is an error code that comes up it is C.7 which is no power to solenoids in the electrical troubleshooting guide that I have, are the solenoids inside the...
  6. A

    Champion 710 A transmission problem

    I have been operating a Champion 710A grader for awhile with no problems today the grader started fine, and I put a small scrape in than it would not go move in reverse or forward. The hydraulics all work fine could it be a transmission solonoid or tranmission problem, there were no problems...
Top