• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Search results

  1. M

    Portable A/C Equipment

    I use Mastercool 69110, came with recovery bottle, Robinair vac pump, OTC scale, and Robinair manifold set. You dont really need the manifold set, but I like it better than just the gauges on recovery machine. All seperate pieces makes it a little easier to load in service truck.
  2. M

    lx885 final drive issues

    Flip the cab. Then "some disassembly required"
  3. M

    Kubota SVL90-2 skid steer AC compressor clutch doesn't engage

    Always a way to bypass. But first make sure condenser fan is not packed with debris which caused fuse to blow. The evaporators on these machines plugged up fast, causing poor AC performance. The AC clutch will not engage if engine is not running.
  4. M

    New Holland lx865 injection pump replacement?

    Procedure in service manual is long and drawn out. Remove valve cover, rocker shaft, measure valve drop......... I remove fuel filter, starter, fuel lines, pump gear cover, loosen pump to gear nut, lock pump, remove pump. I use a degree wheel to note where pump shaft is in relation to scribe...
  5. M

    How do I check oil in LX865 chain case & where is the dipstick?

    If I recall the early models had dipstick by your feet, those had gear oil in the final drive and 10W30 in the chain case. Later serial number the final drive and chain case were "common". But it was '94 or '95 when I went to that school.
  6. M

    New Holland Ls180

    Sometimes debris gets between hyd oil temp sensor and right side servo arm. This can pull sensor loose and cause leak. I usually end up dropping pans, tilting cab and cleaning spotless. You can get a lot of man hours in just cleaning to pin point a leak on those creatures. Check pump drive...
  7. M

    New Holland LX665 error and hydraulic issues

    Check the start interlock relay.
  8. M

    Case 580L Injection Pump

    I have had a couple Perkins engines with excessive play in the idle gear cause CAV pumps seize, but the worn idle gear bushings were caused by an overloaded hydraulic pump that ran off the same gear. Those cases were not from hitting the hyd. relief valve every now and then but from planters...
  9. M

    Case 580L Injection Pump

    I have on my hands a 580L with a seized injection pump. My fuel man said there was no signs of contamination to lock it up and the injectors not stuck, maybe an alignment problem. Looks like the pump gear is running off the cam gear. Has anyone had problems with cam bushing wear to get pump...
  10. M

    New Owner of a 30e Massey Ferguson Backhoe

    What do you mean by "front half"? You have a pressure line and suction line and two bolts that hold pump to front axle housing frame. Sometimes the pump won't slide out of shaft when the splines are half worn. A couple long pry bars should get it. When you get pump out of shaft, the shaft...
  11. M

    Newholland LS 190 dies constantly

    F 04 only means power was cut off to fuel shut off solenoid.
  12. M

    New Owner of a 30e Massey Ferguson Backhoe

    The blue thing is the solenoid. Three terminals on each side. One side is forward the other reverse. You only use two terminals on each side, one hot, one ground. I don't remember which two terminals to use but you can ground one and power another and figure it out. You should be able to hear...
  13. M

    New Owner of a 30e Massey Ferguson Backhoe

  14. M

    New Owner of a 30e Massey Ferguson Backhoe

  15. M

    New Owner of a 30e Massey Ferguson Backhoe

    That's power shuttle not instant reverse. Most problems with that trans is electrical. Uses MF permatran fluid. There was a forward and reverse switch at the pedals and inline diodes up at the solenoid. You can shoot 12 volts to the solenoid. One side is forward one reverse. Have the drive...
  16. M

    New Owner of a 30e Massey Ferguson Backhoe

    That's power shuttle not instant reverse. Most problems with that trans is electrical. Uses MF permatran fluid. There was a forward and reverse switch at the pedals and inline diodes up at the solenoid. You can shoot 12 volts to the solenoid. One side is forward one reverse. Have the drive...
  17. M

    new holland LX-985

    Those had a habit of charge pump going out. Does charge pressure light come on? Check charge pump pressure.
Top