• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Search results

  1. J

    320B governor actuator

    thanks for the info.
  2. J

    320B governor actuator

    Want to replace my governor actuator its mounted under the engine. Old one had top cable to top of injection pump lever and bottom cable to bottom lever but my parts book shows cables vise versa so a little confused anyone know what is proper hook up.
  3. J

    320B excavator throttle

    Does any one have diagram on how to remove throttle dial intermittent connection when I wiggle the dial it works assuming dirty or failing.
  4. J

    Cat 315

    mine works but have to block rad to get heat. If ts cold -10 C it has to idle before heater or lights kick in but i don't run my excavators if its much below that.
  5. J

    sweeps

    need to put sheet plate on top of my open sweeps wondering what thickness and if it should have a cross break done to stiffen it.
  6. J

    v brush cutter

    Thinking about a brush cutter don't know much about them pros and cons.Been tramping it down then piling with cat.
  7. J

    trans temp

    My D6H LGP with 15 ft blade trans runs at 200-205 F is that normal op. temp drops quick when i stop engine runs 185 F.
  8. J

    New year

    Happy Year to everyone.
  9. J

    injection pump

    Thanks its mechanical pump pump went on same way it came off so i think timing is correct.
  10. J

    injection pump

    had my injection pump rebuild on 315B cat excavator started a couple times fired right up but now it spins over probably 5 times before it starts runs good never a issue before the reason for rebuild was it was starting to flutter when it would go to idle cat rebuild engine 2 years ago
  11. J

    Cat 315L Weak Travel on Right track

    my 315bl did the same i resealed the swivel and works the way its supposed to after that.
  12. J

    320B swivel

    thanks fellas.
  13. J

    320B swivel

    My one track travels slower than the other one so i want to remove swivel to reseal.My question is do i have to drain hydraulic tank to remove hoses.
  14. J

    Repairing older style dozer final drives D6D

    Had a friend that ran those older cats he told me if your doing the final drives go with cat easy stuff to get at use after market he would do his finals every 3 thousand hrs. he always replaced the bearings gears he would sometimes just switch sides.
  15. J

    320b wiring harness

    Thanks Nige appreciated
  16. J

    320b wiring harness

    From manual dignotstic supposed to have 0 at throttle dial have 16v serial 6cr
  17. J

    320b wiring harness

    Was having throttle issues came down to replace wiring harness H and A can't find it in the schematic or parts book anyone know about these
  18. J

    cylinder sleeve removal

    i had mine bored 25 over can go to up 50 dry sleeves cat excavator engine said it was way cheaper to bore it out.
  19. J

    320BL engine oil dipstick

    do most of these excavators not show right in the morning mine shows add or below wipe it off try a again and it shows full my 315BL is the same engine oil
  20. J

    new cam and lifters

    thanks for the info.
Top