• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Search results

  1. H

    Gmc 6.5 diesel heating

    I have a 1999 gmc heating fine driving down the road or with idle up but let off at a light and heater drops off fast temp. gauge reads normal but no heat , tried bleeding several times still not much better any help ?
  2. H

    3 cylinder deere oil in coolant

    Checked into unit closer no oil cooler for motor oil , pulled head no real noticable spots a couple of questionable spots ,had head plained as per my customers request and new gasket tomorrow.
  3. H

    3 cylinder deere oil in coolant

    Have 3 ciy deere oil in coolant , not coolant in oil . could be, oil cooler,head gasket,liner pin hole ? were to check first. Thanks
  4. H

    john deere 310D

    thanks for the leeds I`ll give them all a try.
  5. H

    john deere 310D

    LOOKING FOR USED 310d transaxle customers unit had no oil and pricing used compared to rebuilding thanks
  6. H

    Komatsu wa 380 a/c wiring

    greetings, looking for wiring diagrams for wa380 a/c , keeps blowing fuse , narrowed it down to cond. curcuit ,or climate control board, any sugestions would be helpful . thanks
  7. H

    massey ferguson mf50 backhoe

    Chris I found it is a MF50F it has forward and reverse directional peddles Thanks Dave
  8. H

    massey ferguson mf50 backhoe

    Thanks Phil, I`ve been looking and can`t find a dealer local , Thanks again, Dave
  9. H

    massey ferguson mf50 backhoe

    Hello I have MF50 backhoe looking for trans breakdown need to replace forward and reverse clutch packs thanks if someone can help
  10. H

    My 580B can not even move!!!

    Hello seen your fluid #2 should be gear oil , but i`d lift the machine using the stabilizers and go in 1st gear see if you have any tire movment with no pressure on them you might have shutle trans troblem usually cold it should get some movement . Good luck
  11. H

    Lull questions and help please

    the serial number is stamped on frame rail and should start with 844 or 1044 in it. As for your lockout I think the pasition sensor on back side of boom tells when to lock check clean and tight good ground. when checking out check hoses in boom for weather cracks nows the time to change instead...
  12. H

    career decision

    Over here in poughkeepsie New York area the money I think is with the homeowners theres a guy that hauls 6wheel pete from local gravel banks and busy every day,most gravel banks don`t have smaller trucks or want to be botherd with the 2-5 yds at a time. Good luck , I`m an independent mobile...
  13. H

    Cat or ingersollrand rollers

    I`v worked for United rentals as a road mechanic for about 7 years and they always buy low price, we had dynapac witch was ok but had old cats that was the only thing for big hills, but for the money dynapac was a good unit very little problems if serviced reg.
Top