• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Search results

  1. bad Tom

    2014 SR210 AUX hydraulic not working

    That's my understanding. There is a utube video on aux hydraulics not working.
  2. bad Tom

    2014 SR210 AUX hydraulic not working

    I don't know much about the newer machines, but the PWM driver might be defective.
  3. bad Tom

    Alpha series SR130 loose coupler

    If you are talking about the upper tilt cylinder pin, then there is no replacement bushing listed. A machine shop could help you out.
  4. bad Tom

    Case XT skidsteer engine RPM range

    They idle at 950 and wire open speed from 2150 to 2650.
  5. bad Tom

    Case XT skidsteer engine RPM range

    It depends on what engine it has. The 40XT is 2150 high idle and 2000 rated load (non turbo), the 60XT is 2450 high and 2200 rated load, the 70XT is 2400 high and 2200 rated load, the 75XT is 2450 high and 2200 rated load and the 85XT, 90XT and 95XT are 2650 and 2500 rated load. All high idle...
  6. bad Tom

    2007 Case 420 Skid Steer

    While adding a case drain to my 420 a couple of years ago, I did not hear my fuel pump make any noise. The pump had failed but the machine ran fine. During the winter, I keep the fuel tank full for pushing snow. Check for 12 volts at the pump before making other checks. Do the easy things first.
  7. bad Tom

    2007 Case 420 Skid Steer

    Power starts at the 40 amp breaker, to the main power relay and then to a 25 amp fuse and then to the fuel pump. At the key switch, check for power on pin A 622 wire in the starting position, power then goes to the starting relay. There are several connectors in there that the power goes through.
  8. bad Tom

    Case 85XT Service Manual

    You can find them on ebay.
  9. bad Tom

    Case 430 alternator wiring - Thin red wire necessary?

    That is misleading, wire 124 does say input to tach, but I think it is the voltage sensor. There is no light for the alt charging. If the alt or battery voltage gets to low or to high, the hours goes off the panel and low or high voltage appears instead.
  10. bad Tom

    Case 430 series 2 wiring diagram

    One button turns on the rear work light with the front lamps and the other one will have the front lights and the tail lamps.
  11. bad Tom

    Case 430 series 2 wiring diagram

    My 420 book has the same diagram as the 440 book, things may look a little different but the wiring is the same. Your 430 should be the same too. The white wire leaves this page, then goes through a flat four pin connector and then back to this page. The beacon light and coupler switch both get...
  12. bad Tom

    Case 430 series 2 wiring diagram

    What do you need to look at?
  13. bad Tom

    Case 440 Oil pressure sensor pigtail

    Your local dealer can get it for you. Part number 87572308 is for the repair kit and was $38.00 as far as I know. You can go the the company website and look through the parts books.
  14. bad Tom

    Case 440 coolant

    ethylene glycol which is regular antifreeze
  15. bad Tom

    Considering 2 used skid steers

    I think a small wheel loader will make a monkey out of a skid steer and you can use the same attachments on them as a skid steer.
  16. bad Tom

    CASE SV340B General Electrical Questions for CASE Owners?

    I think you are talking about the "front electric" connector, 13 pin that controls equipment. You will have three switches on the joysticks that runs your attachments.
  17. bad Tom

    Case 1840 temperature light and buzzer?

    That sender works on several skid steers from 1835C's up through 1845C's, graders and dozers. You will be fine.
  18. bad Tom

    Case 1840 temperature light and buzzer?

    I think you found it. Unplug it and see what happens. But if the wire has grounded to the frame, then the light will still be on and the sender should be good. So, keep checking.
  19. bad Tom

    Case 440 fuel injection pump solenoid

    I looked at my 440 and the injection pump is out in the open, easy to get to. Take the plate off of the side of the cab (if you have not done that yet) and there it is.
  20. bad Tom

    Case 440 ignition wiring diagram

    Engine oil pressure.
Top