Do JD 710B and 310B backhoe buckets interchange?

Scout_1969 · Jun 6, 2021

Part number AT158374 is stamped on bucket.
Cant find that number or pins diameters or lengths on Deere’s site, to see if they interchange. Buckets don’t appear to have the same part numbers. The 710’s are beasts I know, but I’m told the backhoe buckets interchange.

Plan to call Deere this week, if no other luck

T-town · Jun 6, 2021

Not sure of that.... but the used buckets I just picked up for my 310b came of a 310d.
1 3/4 inch dipper pin and 1 1/2 bucket pin... j

Scout_1969 · Jun 6, 2021

Good to know, if I can find a D series 18” bucket it will fit my B series

T-town · Jun 7, 2021

Yeah... this was a private sale.. I just had em measure the distance on the pin bosses and the pin dia. and all was well compared to my bucket.

Jimbo · Jun 10, 2021

Not even close.....The pin diameter on a 710B,C,or D is 65mm
The pin size on a 310 or 410 is substancially smaller, my guess would be around 50mm or so
The 710 series are nothing short of a rubber tired excavator, weighing in nearly 5 tons more than a 310
As a side note, 710B,C,D loader backhoe buckets will swap with a 120 size excavator bucet, without quick tach(the pin spread is different)

Scout_1969 · Jun 10, 2021

Thanks for confirming and the information. They measured the holes and the dipper pin hole is 1.75” ID and the curl cylinder hole is 1.5” ID, so it will fit my 310B.

AzIron · Jun 10, 2021

Your 310 will just lay down on you and be very unproductive with a 710 bucket they are physically twice the size

Do JD 710B and 310B backhoe buckets interchange?

Scout_1969

Well-Known Member

T-town

Senior Member

Scout_1969

Well-Known Member

T-town

Senior Member

Jimbo

Well-Known Member

Scout_1969

Well-Known Member

AzIron

Senior Member