Any tips or tricks to get this rusted in pin out. Was going to apply some heat, but don’t want to mushroom the ends. Thanks
Yep, I just want to reseal the cylinder. Thanks for the tip.If you're just trying to reseal the cylinder don't remove it. Remove the pin on other end and take the cylinder apart. I always hook the rod end back up to the machine anyways to loosen the nut.
If a better penetrating oil is needed, try a homemade one; 1/2 ATF and 1/2 acetone. I've seen that concoction work miracles, especially when heat is also used.
I have done it this way several times and you don’t have to find the pin every time a rock hits that flimsy snap ring later.If you're just trying to reseal the cylinder don't remove it. Remove the pin on other end and take the cylinder apart. I always hook the rod end back up to the machine anyways to loosen the nut.