mg2361
Senior Member
Click on his username, then start a conversation.
The Angle sensor (A-Sensor) is mechanically linked to the pump valve plate. It converts its physical position to a voltage signal and sends this signal to the controller (PVC).STILL SHOWING CODE 22 checked wired to solenoids all seems good and valves are working can’t find any-problem there.. there is one pressure switch faulty behind the cab but from what I understand then don’t have anything todo with controling the pump am I right??
And there’s a sensor of some kind on the dipper supply pipe coming of the valve chest any one know what that is or what it’s for ?
The Angle sensor (A-Sensor) is mechanically linked to the pump valve plate. It converts its physical position to a voltage signal and sends this signal to the controller (PVC).
So that we also have to check the mechanical linkage.
View attachment 233855
View attachment 233856
View attachment 233857
What’s the best way to check the angle linkage?
and if that’s all good could it be a fault in the pvc itself??
View attachment 233867
- It's easy to check whether PVC's working normal or not. You can look at the RED LED on top of PVC.
- Take-out A-sensor==> operate any function==> look at the hole on pump. Also take this opportunity to examine the main pump solenoid valve.
View attachment 233868