Thank you.
This lift has the upgraded blue boards with LED display on the side. After repairing the boom extension, I was using it and stowed when finished, when I came to use it again I get error 0010 when on lower control or platform.
Here is what I have done. 6 conductor wire between lower and upper checks out fine. for continuity.
disconnected platform control and plugged in at bottom - no difference.
visually inspected all 3 boards both side for damage or burnt out areas - none
On each board I see test areas, but have no way to know what to test for. I believe it is in the communication between platform and lower CPU somewhere. Have checked as many traces and wiring as I can follow to make sure no breakages.
I was hoping software would allow me to see if there was any communication between boards and if not which board was not doing its startup routine.
Platform board, receives 24v, less are constantly flashing. and do not go solid. I can start the engine from lower but never changes over to engine power.
Everything works in down only as rewired with code 0010 according to the service manual.
I know I am looking to fault find to the component level, as to switching a board for $1000.
Thanks
Paul