So we have a CAT 966f II that we dont use a lot. Backup basically. Doesn't get a lot of attention. I was running it today and thought the cycle time on the loader seemed unusually slow. So I was noticing that I cant raise and curl at the same time, raise and dump at the same time, etc. Do these model loaders not allow you to run two functions at once like the newer loaders? I haven't ran it in forever but I swear you could multifunction. Or is there a specific issue we need to have repaired? When I pull both levers there is no bog down at all. The bucket curl/dump function takes priority if both levers are being pulled. Like if I am lifting and try to curl the bucket at the same time the loader arms completely stop and the bucket will start to curl. Then when I let off the bucket lever the loader arms resume. Hope some of you can help. Thank you.
-
Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!
966F II issue?
- Thread starter S120483
- Start date
Bls repair
Senior Member
I would check pressure and flow rates. Check to see if controls are fully functioning
mody2009
Member
Hello , I am interested to Cat loaders if you would like to sell this Cat 966F or if you get any others that you like to sell .
please let me know
please let me know