Does anyone recognize this master cylinder control for a Gearmatic 19

Dougie G · Jun 16, 2019

I need to find out what model these master cylinders are so I can rebuild them. They are controls for my Gearmatic 19 winch on my 450 Timberjack line skidder
Thanks

Plebeian · Jun 17, 2019

Anything in this lot?
https://forestryparts.com/gearmaticwinchparts.aspx

crane operator · Jun 17, 2019

kinda looks like a old mico mastercylinder. They were used in everything 70's-80's. Napa used to have a good parts book that you could leaf through and find something that looked like whatever the equipment had.

Dougie G · Jun 17, 2019

Plebeian said:
Anything in this lot?
https://forestryparts.com/gearmaticwinchparts.aspx

No, I have some of these in the shop manuel, but thx

Dougie G · Jun 17, 2019

crane operator said:
kinda looks like a old mico mastercylinder. They were used in everything 70's-80's. Napa used to have a good parts book that you could leaf through and find something that looked like whatever the equipment had.

I will give them a try, Thanks

mitch504 · Jun 17, 2019

Going the NAPA route you will probably have to take it apart an get the bore diameter before you go there, but that is probably your best bet.

DMiller · Jun 17, 2019

Wagner made a style similar and typical to IHC or old GM medium trucks. Check for a 1975 Loadstar 1600

walkerv · Jun 17, 2019

Same looking master as a 65 cj5 jeep. Just dig into them and get the seals out so they can be matched up .

Does anyone recognize this master cylinder control for a Gearmatic 19

Dougie G

Well-Known Member

Attachments

Plebeian

Senior Member

crane operator

Senior Member

Dougie G

Well-Known Member

Dougie G

Well-Known Member

mitch504

Senior Member

DMiller

Senior Member

walkerv

Senior Member