case 9050b control switch

i just rently purchased a 9050B case and the controls was wrong for me , i need to switch to the john deere control, i seen a old post on here how to switch 4 hoses on the lower part of the manifold behind the cab and did , the controls are now right but my stick and boom work the opposite way they should , does anyone know the hoses i need to switch for those 2 controls? i dont have a manual or schematic. thanks

Is this a "B" series machine?

yes it is

Coy Lancaster said:

Is this a "B" series machine?

Click to expand...

Ok I'll to explain this to you as best as I can. On the block at the back cab on the bottom there is a series of hoses, there are three close to the outside edge you will need to take the front one and the middle one off to get to the one inside hose fitting. That one hose second from the outside close to the cab remove it and swap it with the hose on the block close to the center of the machine on the rear corner. Then remove the hose on the outside rear corner and swap it with the hose on the front corner inside toward the center of machine. Be sure and swap the hoses on the bottom of the block where the pressure are.
I hope this helps, oh BTW if the color code tags are still there it is let me know where they are located should be pink,blue,green and red, I can't remember where they are located for factory control setup.

@Coy Lancaster like this ? i did this already and everything is on the right joysticks , but the boom and stick are backwards

Well you did it wrong put the lines back like they were. The swap the hoses corner to corner in a X pattern.

I just switch the pattern on my Link Belt 4300Q which is the same as Case 9050B. From the picture above switch A3 for A8 and A4 For A7. A4 is the hose in the center with an extension on it. You'll have to remove A7 and the hose between A7 and A8 and well as both of the adaptor fittings on those two hoses to get to A8. You may have to remove the hose on the opposite corner and unplug a pressure sensor to get to A4. BEFORE YOU UNHOOK ANY HOSES BE SURE TO RELEASE PRESSURE FROM THE HYDRAULIC TANK WITH THE PULL VALVE LOCATED ON TOP OF THE TANK NEAR THE FILL CAP.