2014 CASE 580N, does not regenerate (lots of codes)

JBV97 · Jun 2, 2019

I have a 2014 CASE 580N that is failing to regenerate automatically after 3 attempts and then goes into a crippled state.

Any help would be greatly appreciated and can someone help me with these codes?

Fault codes: @3053hrs
3104
37991
7323
3105
3811
3112

Codes @ 2994hrs
1045
17488
19106
3260
17476
17297

mg2361 · Jun 3, 2019

Welcome to HEF JBV97

! There is a wealth of knowledge on this sight and I am sure someone with Case experience will be along shortly to help you out.

Coy Lancaster · Jun 4, 2019

Welcome to HEF: you could contact your local dealer and they should help you with the codes.

Coy Lancaster · Jun 4, 2019

I found a fault code list by searching Case 580N fault code 3104, a site www.altaimpl.com came up in list and showed the whole list of fault codes, which I copied off for my own use.
3104 code is "Rail pressure relief valve - open"
3105 code is " Rail pressure relief valve - pressure shock requested
I hope you can find what I stumbled up on
The only thing it didn't list any five digit codes

JBV97 · Jun 4, 2019

Coy Lancaster said:
I found a fault code list by searching Case 580N fault code 3104, a site www.altaimpl.com came up in list and showed the whole list of fault codes, which I copied off for my own
Use.
3104 code is "Rail pressure relief valve - open"
3105 code is " Rail pressure relief valve - pressure shock requested
I hope you can find what I stumbled up on
The only thing it didn't list any five digit codes

Thank you for the reply. Ill have a look. Unfortunately, I live on an island in the Caribbean which does not have a dealership, so whenever the backhoe goes into limp mode, it is very expensive to get someone to fly out and reset the machine.

Any ideas why it does not regenerate on its own?

Also, is there any software that I can use that can perform the regeneration function? Thanks

Coy Lancaster · Jun 5, 2019

More than likely the reason it will not regen. is because of all the fault codes. You will have to take care of them before normal operation will proceed. You can look online to see if there are any software for your computer so you can diagnose and repair your machine.

gggraham · Jun 5, 2019

3 of the codes are rail pressure errors the 3000's, check for air in system. Also remove the pressure sensor from the rail and reinstall do not over torque, over torquing can cause rail pressure errors. One code is sytem voltage too high, check alternator output.

gggraham · Jun 5, 2019

Error 1045 is a bad fuel level sensor

JBV97 · Jun 6, 2019

Thanks everyone for the assistance so far.

Would something like the TEXA laptop or software be able to work? The dealer insisted only the OEM software can work.

2014 CASE 580N, does not regenerate (lots of codes)

JBV97

New Member

mg2361

Senior Member

Coy Lancaster

Senior Member

Coy Lancaster

Senior Member

JBV97

New Member

Coy Lancaster

Senior Member

gggraham

Senior Member

gggraham

Senior Member

JBV97

New Member