Leighva
Active Member
Any thoughts or experience with Sharq P300 cutting edges?
I plow all winter in steep Rocky Mountain logging roads and wonder if anyone knows how they hold up?
https://www.sharqedges.com/products/for-snow-and-ice/sharq-p300
I’ve watched some video clips with good reviews but little was said about hitting donikers buried above grade in the road surface.
Rep said you can’t grade in float either... it cuts too deep. Some operators state they won’t go back to a conventional flat cutting edges after switching over to these. They say less down pressure is needed resulting in the operator running lower RPM’s and a taller gear. This results in up to 20-40% less fuel consumption.
Thx for your comments.
I plow all winter in steep Rocky Mountain logging roads and wonder if anyone knows how they hold up?
https://www.sharqedges.com/products/for-snow-and-ice/sharq-p300
I’ve watched some video clips with good reviews but little was said about hitting donikers buried above grade in the road surface.
Rep said you can’t grade in float either... it cuts too deep. Some operators state they won’t go back to a conventional flat cutting edges after switching over to these. They say less down pressure is needed resulting in the operator running lower RPM’s and a taller gear. This results in up to 20-40% less fuel consumption.
Thx for your comments.