Having issues with our Genie s125 where the boom wont extend out and the axles are out all the way as far as i can tell. The serial number is s12511-2914. When you try and function the boom from the lower control panel it beeps and points to the axles on the display. I have inspected the roller switches on the axles and they at least seem to be functioning. I tried to follow genies procedure for ohming them but i obviously don't know what I'm doing. I can tell you that with a power test light it doesn't matter if the switch is activated or not the two outer wires have power either way, or inner wires depending on your angle. That goes for both axles. Each axle has what appears to be 2 proximatey magnets also. I was going to attempt to test those but ran out of time and pulled a wire out the back of a connector so i was not happy!
Any advice? Isnt there a way to narrow it down to one of the sensors with the machines diagnostics?
Any advice? Isnt there a way to narrow it down to one of the sensors with the machines diagnostics?