Zane Payne
Member
I have a 272C Cat skidsteer with 725 hours on it and the right joystick which controls bucket functions is completely dead. What do I need to check out first? Please help.
If your machine has an enclosed cab you may want to check the door interlock switch. If the machine thinks the door is open it will lock out the implements. This is to prevent an operator from leaving the front door open and raising the liftarm, which would destroy the door.
The door interlock switch seems to be working fine. What next?Alrighty I will check that this morning. Thanks.
I checked the door interlock switch and it seems to be working fine. What next?hi ,your machine will have a serial number prefix of RED however for accurate information I will need the full serial number or at least the range RED1 to 1359 0r RED1360 and up
for starters check the fuse #9 as it supplies power to the right hand joystick and check that the ground is good
Mark
hi ,your machine will have a serial number prefix of RED however for accurate information I will need the full serial number or at least the range RED1 to 1359 0r RED1360 and up
for starters check the fuse #9 as it supplies power to the right hand joystick and check that the ground is good
Mark
Are there any fault codes? If your machine has a display hold the function button and the up button for a few seconds and it should go into service menu. If I remember correctly mode 1 is active diagnostic codes and mode 3 is active event codes.
It doesn't have the display screen on the right.