I have a new to me 2006 Case 650k Series 2. It has been sitting with very little to no use the last 2-3 years. One issue I'm having is the Transmission Fault light comes on immediately after cranking the dozer, even before I move the joystick. Also, the display is not showing F, N, or R. And the transmission speed gauge is not working (immediately after cranking the needle drops, but goes back to zero) .
However, the machine seems to run and operate fine in all directions. The bump up and down buttons also work fine.
I have cleaned the battery terminals, checked fuses, etc. Also, I checked a few things on the 9 pin deutsch diagnostics connector based off GaryHoff's recommendations on an older thread concerning a Case 850k.
Key off:
C to D=117ohms
Key on;
A to B =12.3v
A to C =2.58v
A to D =2.45v
Any recommendations on what I should be checking from here?
Thanks!
However, the machine seems to run and operate fine in all directions. The bump up and down buttons also work fine.
I have cleaned the battery terminals, checked fuses, etc. Also, I checked a few things on the 9 pin deutsch diagnostics connector based off GaryHoff's recommendations on an older thread concerning a Case 850k.
Key off:
C to D=117ohms
Key on;
A to B =12.3v
A to C =2.58v
A to D =2.45v
Any recommendations on what I should be checking from here?
Thanks!