• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Cmi rs500

S

steed6557

Active Member
Joined
Aug 23, 2011
Messages
31
Location
Florida
We just bought this machine and it goes through carbide bullet teeth very quickly, does anyone make diamond tip teeth for this machine. Also, it uses a 8v1400 belt for the drum drive, it is going through one of these a week. The belt pulley has 6 inches of adjustment on it but the belt only allows for two inches of adjustment. A smaller 8v1320 belt is too small, does anyone know of a manufacturer that can supply a belt at say 1360? Finally, I have been trying to get parts and service manuals for this machine, local dealer here is next to useless, Terex won't help so if you know a dealer that likes to do business in country then please advise, thanks.
 
Y

Yetiologist

Member
Joined
Apr 5, 2013
Messages
5
Location
Iowa
steed6557 said:
We just bought this machine and it goes through carbide bullet teeth very quickly, does anyone make diamond tip teeth for this machine. Also, it uses a 8v1400 belt for the drum drive, it is going through one of these a week. The belt pulley has 6 inches of adjustment on it but the belt only allows for two inches of adjustment. A smaller 8v1320 belt is too small, does anyone know of a manufacturer that can supply a belt at say 1360? Finally, I have been trying to get parts and service manuals for this machine, local dealer here is next to useless, Terex won't help so if you know a dealer that likes to do business in country then please advise, thanks.
Click to expand...

What type of teeth are using on this machine?? Are they breaking, shattering tips, throwing carbides or is it just wearing or washing them out? I might have a solution to your problem so send me an email if it is convenient.
 
Y

Yetiologist

Member
Joined
Apr 5, 2013
Messages
5
Location
Iowa
Especially when you know the origin. How goes it? I thought I had better join to make sure I keep up on the goings on around here.
 
laycobeau

laycobeau

Well-Known Member
Joined
Jul 8, 2013
Messages
219
Location
Tulsa Ok. beau.bowlan@lei-corp.com
Occupation
Lead electronic technician
I can repair the micro controller for you if it goes bad. you can down load the manual from cmi/terex web site.
if not e-mail me and i will send you a link.

Beau Bowlan
lei-corp.com
 
You must log in or register to reply here.
Top