• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Champion 710A

Adam Walden

Adam Walden

Active Member
Joined
Dec 19, 2021
Messages
29
Location
30143
I have a champion 710A in my shop, it will not take any gear. I pulled the strainer in the trans, it didn't have clutch material or anything that would lead me to believe I needed tu pull the trans, the owner said it would move when he parked it a couple years ago. I checked the pressures on the trans pump, they were just a little under spec at operating temp so I changed the pump, that didn't help, any suggestions would be greatly appreciated,
 
D

DB2

Senior Member
Joined
Jan 4, 2015
Messages
1,007
Location
Winnipeg MB Canada
Yes a 9150 was a powershift with 3 speeds and a manual high low. Depends on the year of the machine. The 8400 came out in around 1985.
 
D

DB2

Senior Member
Joined
Jan 4, 2015
Messages
1,007
Location
Winnipeg MB Canada
First thing I would check is if the drive shaft between the clutch and transmission stops spinning when trying to start moving. Could be a clutch issue as well.
 
W

Welder Dave

Senior Member
Joined
Oct 11, 2014
Messages
12,533
Location
Canada
Don't think there'd be a declutch but need to figure out what transmission you have. Power shift is too vague. If it's an 8400 it wasn't uncommon for the solenoids to go out or act up from what I've read.
 
You must log in or register to reply here.
Top