tractormech
Senior Member
Hello all- I have a a 334G ser 234514534 that the two speed travel quit working. Any Bobcat gurus have any tips or insight. I have a shop manual but the electrical schematic is incomplete. Any advice is appreciated. Thanks!
-
Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!
334G no two speed travel
- Thread starter tractormech
- Start date
uffex
Senior Member
Good day
According to my information, the two speed is controlled by a solenoid valve No.49 on the schematic I have read, the second unit from the accumulator. I suggest first check out if this is getting a signal when you switch. The coils are common, so you can switch to eliminate. My wiring schematic is not so good, if you like to share the correct one I can try to help some more.
Kind regards
Uffex
According to my information, the two speed is controlled by a solenoid valve No.49 on the schematic I have read, the second unit from the accumulator. I suggest first check out if this is getting a signal when you switch. The coils are common, so you can switch to eliminate. My wiring schematic is not so good, if you like to share the correct one I can try to help some more.
Kind regards
Uffex
tractormech
Senior Member
It is spool #7. No power is going to it. When you press the 2 speed switch button the controller "rabbit" icon does not come on either. I've checked the two speed switch button with an Ohm meter and it's checking good. I then suspected the controller was bad so I switched out the controller with a known good unit and still nothing. It's a witch hunt.
uffex
Senior Member
Good day
Have you tried an indepedant feed to the high speed valve?
Kind regards
Uffex
Have you tried an indepedant feed to the high speed valve?
Kind regards
Uffex
uffex
Senior Member
tractormech
Senior Member
Thank you for the input. I have not tried independent feed yet but I'm getting a 13-07 and a 33-23 code.