JRsEquipment
Well-Known Member
The hydraulics or trans are killing the engine no matter what, just start it don't move any levers or put it in gear and the engine loads up really bad and dies. Wont spin over with the starter unless you let it sit for a minute or 3 and fires back up and does it again. Everything works, even if you drive machine or operate hydraulics engine still binds up and dies. Machine was dropped of here for left steer clutch not disengaging, they unloaded it and drove about 300ft so it wasn't doing it until sat for a few weeks now only runs for a min or so or I can travel about 10 ft. Anyone familiar with this machine or any ideas where to start??
Thanks!
Thanks!