• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Recent content by samk

  1. S

    Oil pan case 2290

    That is the picture that I am looking at
  2. S

    Oil pan case 2290

    Yes there are different size bolts , the gasket in question is number 40
  3. S

    Oil pan case 2290

  4. S

    Oil pan case 2290

    The plate on the engine is. A504bdt. And 10303289
  5. S

    Oil pan case 2290

    It is a 504 with turbo and the tractor is a 2290 case. Unfortately I will have to go to the next farm to find the serial number
  6. S

    Oil pan case 2290

    Finally finished new cylinder o rings and have the pan installed. When I removed the torque cover plate I paid no attention as to whether there was a gasket between the cover and the oil pan itself. It appears as though the pan gasket set has one but when used the cover will not raise high...
  7. S

    Oil pan case 2290

    Finally finished new cylinder o rings and have the pan installed. When I removed the torque cover plate I paid no attention as to whether there was a gasket between the cover and the oil pan itself. It appears as though the pan gasket set has one but when used the cover will not raise high...
  8. S

    Oil pan case 2290

    This, I know is a rally dumb question .I installed new sleeve o rings in the tractor and all went well. The installation of the oil pan went well,howevever when I went to install the torque cover it seems that it will not sit high enough to install the bottom bolts as the cover has to go about...
  9. S

    Cat 426 oil pressure

    The engine was reliably rebuild and was faultless for about 100 hours so if a head gasket was improperly installed the problem would have surfaced long before now I thank you for the input and will keep you posted Sam
  10. S

    Cat 426 oil pressure

    My backhoe (cat 426) has just recently started to bring the oil light on after maybe 30 seconds of running. The engine has maybe 100 hours of running after a complete rebuild with no problem. I pulled the sending unit and inserted a mechanical gauge and the engine will run about 60 p.s.i. For...
  11. S

    Dynahoe 190 series 3

    I am in the process of getting some brakes on this beauty but am having one heck of a time trying to locate a master cylinder. I have taken the old one in to the local parts store with no success. I am sure that Wagner does have a match but I am sure that the parts guy just doesn’t want to take...
  12. S

    Case 580ck

    I am in agreement with you. The reason that I am leaninining in that direction is that the very slow shift only occurs after about 20 minutes of work ,but if I shut off the engine and restart it will immediately go into gear. While I am at it I plan to pull the shuttle valve body etc. To check...
  13. S

    Case 580ck

    I am leaning towards something along the same lines Sam
  14. S

    Case 580ck

    Will do . But as I mentioned it will work great for at least 20 minutes of work ,then become very slow to shift from forward to reverse using the shuttle shift, Even when this slow shift occurs ,it still will push strong
  15. S

    Case 580ck

    Do not recall what brand I put in the last time and as for the pressure readings I am waiting for some adaptor fittings The one thing that I did notice was that the failure for the shuttle to quickly engage happens after about 20 minutes of working,but if I turn the motor off for about 20...
See more
Top