• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Recent content by polco

  1. P

    Genie s-40 starts then stalls

    I replaced the cam sensor but that was not the problem , still shuts off after 2-3 seconds. ????? I will find an electrical schematic for that and start tracing wires, maybe a shorted wire or open circuit?
  2. P

    Genie s-40 starts then stalls

    I am still working on it . I replaced the oil pressure switch and it still does the same thing, runs 2-3 sec. and shuts back off. I took off the cam position sensor and having that checked out. Will let you know if that is the problem. Jon
  3. P

    New Holland t33d info

    Thanks, I will look them up
  4. P

    Genie s-40 starts then stalls

    The circuit breakers on the control panel are O.K. , I noticed that it had oil pressure the short time that it ran. I believe it has an oil pressure switch and a sending unit. I will check them out next, Thanks for the quick response !
  5. P

    New Holland t33d info

    I have a 2003 New Holland t33d model that I need a operators or service manual for . Anybody know of a site to download one, Thanks
  6. P

    Genie s-40 starts then stalls

    I have a 1999 Genie s-40 425lrg [2.5 ] EFI motor, The last user put diesel fuel in the gas tank, about a 50/50 mix . I drained the gas tank and installed a new fuel filter and after a dozen tries it started. It smoked a little and I ran it at high speed and at idle for 5-6 minutes and then I...
See more
Top