• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Recent content by PAULTY

  1. P

    Looking for Genie Software

    Yes. to the ribbon cable. All the ribbon cables ohm out, as does the connections. Had a bad 2500uf capacitor which I replaced, but still no go. So I reinvented the wheel. All the wiring has been replaced except for the boom to platform. I have been able to replicate the software on a micro...
  2. P

    Looking for Genie Software

    Forgive the autocorrect.. Thank you. This lift has the upgraded blue boards with LED display on the side. After repairing the boom extension, I was using it and stowed when finished, when I came to use it again I get error 0010 when on lower control or platform. Here is what I have done. 6...
  3. P

    Looking for Genie Software

    Thank you. This lift has the upgraded blue boards with LED display on the side. After repairing the boom extension, I was using it and stowed when finished, when I came to use it again I get error 0010 when on lower control or platform. Here is what I have done. 6 conductor wire between lower...
  4. P

    Looking for Genie Software

    I have a 2002 Genie TMZ 50 and I am hoping to find the software to interface to it and diagnose. Any help would be appreciated. Thanks Paul
  5. P

    3D printed tool

    Just my 0.02c I have used ABS and PLA plastics in a oil filled drive shaft to replace a RPM gauge drive. This was a drive rod with a gear that just span and told the gauge the RPM. Still working to this day. I have table feed gears inside my horizontal mill that are 3d printer for the Automatic...
  6. P

    Extension Boom Stuck

    Just to update anyone... I took the boom out and the cylinder out. Cylinder is 7feet long retracted. The cylinder would turn/twist fine but would not retract. I took both counter balance valves out and the cylinder would not budge. However I lifted it up and the weight of the ram moved slightly...
  7. P

    Extension Boom Stuck

    I was using it and it was extending and retracting fine, then I extended it out to reach an area and then when I finished and was ready to come down it would not retract back in. The steel box section stops me from removing the 2 counter balance valves but I can adjust the lower side one all the...
  8. P

    Extension Boom Stuck

    Genie TMZ 50 Serial 5002-194 Boom extension was working great no problems, and then would not retract. Now no out or inwards movement, Tried replacing valve with a known good one at manifold, same with solenoid. Fluid flows to both side of the cylinder. When I disconnect hose. I have counter...
  9. P

    1999 Genie TMZ 50/30 Outrigger Failure

    Is it flashing a code on the left hand side of the ground control box.?
  10. P

    TMZ 50/30 Swing help

    Yes. I can move the boom freely by pushing the end both directions, as long as someone holds the button, I have taken the pump and brake off and inspected. I initially thought the motor had blow by and was expecting the pressure to drop, but I found it held 2800 on electric pump and never built...
  11. P

    TMZ 50/30 Swing help

    I have a 2002 TMZ 50/30 towed aerial lift by Genie. Serial No. T5002-194 The problem I have is with the rotation of the lift. With battery power and using ground control swing moves freely and without problems, hydraulic pressure tested at 2800, if I use engine power and ground controls the...
See more
Top