• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Recent content by partsman11

  1. P

    Lull 1044c-54 Brake stuck going forward

    1044C-54 We found a bad relay It’s fine now Thanks for the reply
  2. P

    Lull 1044c-54 Brake stuck going forward

    my machine was fine and started blowing fuse f5 Solenoid S4 was bad I replaced it and the boom will lower and extend now Somehow while testing a poking around, my machine acts like the brakes are on going forward Neutral and reverse are fine You put it in forward and it acts like you are...
  3. P

    Geith EK-30 Thumb wanted

    Hello I am looking for a Geith Ek30 thumb for my Kobelco SK 200. It is a manual thumb. i have the stiff arm and the brackets welded on the machine. I have run down 3 leads in publications but they are all sold. Any help would be appreciated. Dan 518-265-0366
  4. P

    Daewoo DD80L

    Does anyone out there own one of these? Looking for common problems to look out for as well as aftermarket parts suppliers. Our local Doosan dealer said they can get parts for it.
  5. P

    Lull 1044C-54 Hydraulic Problem

    We cleaned suction and return filter Worked good all day today! They didn't seem real dirty Must be enough to restrict flow Cold Thank you!!
  6. P

    Section for komatsu d20,21 and similar grey market dozers

    Thank you ! I just sent him a message
  7. P

    Section for komatsu d20,21 and similar grey market dozers

    I have a D20P-7 It started smoking blue really bad. It has gotten worse. A lot of blowby It has a 4D95S-1 engine which is built by Yanmar. Any ideas where to get a rebuild kit? I called a Yanmar Distributor they claimed if they have the Komatsu part#s converted to Yanmar they can provide it. Any...
  8. P

    Lull 1044C-54 Hydraulic Problem

    Hello I'm am in need of some assistance in repairing our LULL. Its a 2003 1044C-54 Serial 18942 3700 hours (sat for a bit outside) Upon start up cold it has slow and very limited use of the hydraulic functions. The boom will go up slow and if you increase the RPMS on the engine, it will cut out...
See more
Top