• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Recent content by Moonlite

  1. M

    JLG T350 towable electric lift won’t go down

    what did you find?
  2. M

    JLG T350 towable electric lift won’t go down

    gonna have to trace the down wire from the ground control box to start with. check where the wires go through the turn table. may have to separate the loom.
  3. M

    JLG T350 towable electric lift won’t go down

    your way of testing is ok. have you verified that you actually have 24 volts at the batteries? also verify you have 24 volts at the ground control panel. (e-stop, key switch, up down switch)
  4. M

    JLG T350 towable electric lift won’t go down

    should be 24 volts. post your serial number and i will verify. or you can google jlg manuals. they have their parts and service manuals online.
  5. M

    JLG T350 towable electric lift won’t go down

    yes you need to check and make sure you are getting 24 volts to the coil. its mounted on the cylinder block near the base of the cylinder.
  6. M

    JLG T350 towable electric lift won’t go down

    that unit does not use the motor to lower. just uses coil to open the spool on cylinder block, to lower by gravity.
  7. M

    jcb 135

    i have a jcb 135 skid steer that was running and died. its not getting power to the fuel solenoid, also noticed that when cranking the display shows 0 rpms. i have checked fuses and relays. any suggestions?
  8. M

    Case 580 super r 2007 WON'T START

    start with the basics. check fuses and connections. it sounds to me like you have left something unplugged or a connection is not making good contact or even a ground wire left off.
  9. M

    Cat d4g

    Well there is an orfice tube in the evaporator core.
  10. M

    Cat d4g

    Well gotta pull the cab on this one after all. Got new compressor, condenser and accumulater. Was flushing system out and I can’t get anything through the evap core.
  11. M

    Cat d4g

    Thanks for the help.
  12. M

    Cat d4g

    Ser hydo2415. Is the orfice tube located at evaporator core? If so is it accessible without pulling the cab. I tried to look up orfice tube in the cat parts catalog, but apparently they call it something else or I’m doing something wrong. Can look up other stuff. Just not that
  13. M

    Bobcat 863 fault code 33-23

    You need to get the controller programmed
  14. M

    jlg 1930es wont power up

    Sounds to me like mice got a wire.
  15. M

    jlg 1930es wont power up

    The manuals also tell how to test the module.
See more
Top