• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Recent content by Lindsey97

  1. L

    Case 1450 loader transmission check

    I'm just guessing here, but all of mine: Deere455g, cat d4c, d8H 46a, all say check transmission warmed up, with engine running at low idle. Sometimes they say on dipstick and have marks on both sides of dipstick, engine running, engine off.
  2. L

    New to me D6C - have some issues

    Drain the engine oil asap and refill with new oil. Antifreeze etches main and rod bearings. Do it even if your not planning on running it.
  3. L

    Cat d8h parts search

    Got fuel transfer pump replaced today and have full pressure at full throttle now. Was pretty easy to repair, only 4 9/16" bolts and the fuel supply line. If you have rubber compression fittings inside your supply line, the part # is 4H-2662. Have a question about 2 open ports on the new fuel...
  4. L

    Cat d8h parts search

    Got the 2 center edges off today, used my 1" air gun. Did not have to cut a single nut, never had that happen before. Did however have to trim the inside edges of the end bits with the gas axe. Is that normally how it's done? I never had to trim cutting edges before either. I'm thinking a...
  5. L

    Cat d8h parts search

    Please specify which 2 bolts. Is the bypass valve inside the fuel pump? Is it the 2 bolts on the side of the pump in my pics?
  6. L

    Cat d8h parts search

    I heard no mumbling. I've been working 7 days/week so I probably uttered some mumbling lol. I picked the $364 transfer pump on ebay, pn matches what cat dealer gave me, 2564756. I suppose I need a gasket as well. Thanks for the help.
  7. L

    Cat d8h parts search

    Horseshoe, shaft, and plungers? I've found 2 aftermarket fuel pumps on ebay, seller is globalpartszone, would appreciate help picking which one is correct. called cat dealer this morning, gave serial # 46A13057, they gave part number 2564756, cost of $1,541.27. Ebay pump is $207.00
  8. L

    Cat d8h parts search

    Been pushing up topsoil and having a good time running the D8. I'm in the process of changing filters and ran into something weird with the primary fuel filter housing. previous owner welded up the bottom of the primary bowl, pn 8H-2810, so I'm replacing it along with the nut, 8H-2807. My...
  9. L

    WHERE TO GET A SHOP MANUAL

    eBay
  10. L

    544C travel speed uphill

    I have a 1985 Case w20C with allison ttx21 transmission. Owned it 17 years. It's always been slow when uphill is involved. I have reverse one speed, and foward 2 speeds. Low foward is a sprag clutch and is slow but very forgiving. Reverse is a gear and pressured clutch and is faster than...
  11. L

    1985 Case 1155D engine removal

    Go rent a bigger machine, like a backhoe, to lift the engine out. Then strip it down later.
  12. L

    JD 450 crawler loader

    Could be low on fluid, or a tiny non leaking pinhole in the suction line.
  13. L

    Fiat-Allis 645B Model & Engine information

    Over here in the states, I had a friend that owned a 545 and 645. He had installed a allis chalmers combine engine in one of his when the engine went down.
  14. L

    1985 Case 1155D engine removal

    We did a complete engine in our Case W20C in 2005. 504BD engine, no turbo, 108hp. Someone had been in it before, and left out some spacers that locate the crank fore/aft in the block. The block was scored, crank ruined, and connecting rods ruin. It ran perfect and only had a small tick at...
  15. L

    Cat d8h parts search

    I never thought of that, I do have an operator's manual, I bet it's in there.
See more
Top